Check out the new tubing notcher from Medford Tool.
It's called the Sync 180.
This little tool is about to change things in the world of chassis fabrication.
The complete SYNCNOTCHING SYSTEMS includes:
SYNC180 notcher
No-Bind drive arbor
5 Snap Collar Locators (for the most common size tubing 1, 1-1/4, 1-1/2, 1-3/4 & 2” ) other sizes available as an option (or you can ask for substitutions on any of these sizes)
180° quick reference jig
EasyNotch© Software CD
EasyNotch© Centerline Finder
6pc shim set (1ea – ¾, ½, 3/8, ¼, & 2ea – 1/16)
FlatBack 16' tape measure
2 Spring clamp holder/positioner
1 Magnetic positioner
1 GripTwist positioner
1 Sharpie
6MM hex key
5/32 T-handle hex key
1 Chip brush
All for the low price of $699.00
This notcher is a complete system designed to simplify the process of notching complex angles and or cuts.
One of the coolest things about the Syncnotcher 180 is the fact that the cutting saw can be rotated around the material 180 degrees. This allows users to make a cut until the hole saw bottoms out, then simply swivil the saw around to the other side and continue the cut.
No need to finish the cut with a different tool,
The quick-clamp jaws allow fabricators to move quickly between material sizes.
And they allow you to clamp up to 2-inch material!
The vice jaws are super solid and self-centering.
Drilling a centerline hole in a piece of tubing is as simple as removing the hole saw.
For more info and to watch videos of the tool in use click here.